MILITARY ART WORK

Design of the navy submarine pin 30" Long Painted silver.  Number needed : Please tell us, if left blank you will receive the item with no number inserted  Pride runs deep has a gold rust patina finish and is attached to the piece by using...

11" In diameter 3/4" Thick Made out of pine

24" Tall 22" Wide Weighs 11 pounds Made out of 16 gauge steel. It has two layers. The back layer has a raw metal finish that has been powder coated clear. The top layer is designed into pieces and attached to the back layer by using 10/24 nuts and...

12" Tall  10" Wide This is a Two layer item that is made out of 16 gauge steel.  Item has been powder coated and painted.  Item is attached together using 10/24 bolts & nuts.  The front layer stands off the back layer about...

24" Tall Weighs 9 pounds Made out of 16 gauge steel. It has three layers. The back layer is powder coated yellow The second layer is designed into pieces and attached to the back layer by using 10/24 nuts and bolts. The pieces have been...

27" Tall  18" Wide  Item weighs 9lbs.  Multiple layer sign. 

Three Layer 7th SFG Crest.  Item is made out of 16 gauge steel, Each layer is connected by using 10/24 nuts and bolts. Powder coated black, Red and the back layer is powder coated Clear to give that Raw metal look    CONTACT US AT...

Item is 18"x13" This item is layered to give it the 3d look, Comes painted with hanger on rear to hang on wall.

12" tall 12" wide  This is a three layer item that is made out of 16 gauge steel.  Item has been powder coated and painted.  Item is attached together using 10/24 bolts & nuts.  The front layer stands off the back layer about...

12" tall 11.5" wide  This is a Two layer item that is made out of 16 gauge steel.  Item has been powder coated and painted.  Item is attached together using 10/24 bolts & nuts.  The front layer stands off the back layer about...

A five Layer Design of 7th Special Forces Group Crest. Item is made out of 16 gauge steel.  Each layer is connected by using 10/24 nuts and bolts, each layer stands 1/4"-1/2" off to give the Crest a 3d look. Each layer is powder coated. 24"...

8" Stainless Steel Cut out of the USAF Seal.